Setting up NETS

I am having difficulty getting the bottom copper pour to be connected to the top copper pour net.

Is there a simple solution?
project
project
2-Layout of Center Section Outside Strip.project
18K
·

Comments

  • edited October 2019
    Yes, Add a via with a node name.
    The developer of AutoTRAX DEX. 
    ·
  • See attached.
    The developer of AutoTRAX DEX. 
    project
    project
    pours.project
    1K
    ·
  • Turn off the top copper and the via connects to the pour but the pour does not connect to the LED fo heat sinking.
    project
    project
    2-Layout of Center Section Outside Strip.project
    18K
    ·
  • What via? There are loads of vias.

    The developer of AutoTRAX DEX. 
    ·
  • and none of them connect to the led vias
    ·
  • on the bottom layer
    ·
  • You have a pad on the bottom that is not connected to signal. This is forcing all vias inside it to not have a signal and so will not connect to copper pours.

    1. Delete the bottom pads.
    2. Covert top pad to TPH
    3. Set hole size to 0
    4. Add vias
    5. Set Pad signal 


    The developer of AutoTRAX DEX. 
    ·
  • edited October 2019
    The developer of AutoTRAX DEX. 
    ·
Sign In or Register to comment.